<aside> ⚠️ Package does not include tools for installation

</aside>

<aside> ℹ️ We recommend using the services of an experienced gunsmith - CZ usualy glues the trigger container and safety selector screws and may need to be drilled out

</aside>

Installation

  1. Pull out the magazine and check chamber of the firearm
  2. Switch the safety lever to self-loading mode and lock the cocking lever in the rear position
  3. Tap out the factory magazine release roll pin from the lower receiver
  4. Fit the magwell over the magazine well lip and insert screw from the left side
  5. Insert the self-locking nut into the hexagon hole at the right side of the magwell
  6. Insert the screw from the other side and tighten using 3mm hex key until you see the bottom of the screw coming past the self-locking nut
  7. Carefully tighten the screw so the magwell is snug and doesn’t move
  8. Point the weapon into a safe area and check the operation of the firearm

https://youtu.be/yqbqWtMnojg?list=PLvJ_L2qlPmk3rhHfKDxe0kj4A69uJxony